Durapol 500 Antislip
Durapol 500 Antislip Car Park System Selangor, Malaysia, Kuala Lumpur (KL), Cheras Supplier, Suppliers, Supply, Supplies | Etepox Solution Sdn Bhd Durapol 500 Antislip DescriptionDurapol 500 Antislip Technical DataCar Park CoatingCar Park Coating 4Car Park Coating 3Car Park Coating 2CP Coating
DESCRIPTION
DURAPOL 500 Anti Slip(Car Park) is a high performance, two components pigmented polyester urethane coating which offer anti slip properties.
USES Design as a finishing coat to resist chemical, ultra violet and abrasion. Suitable  concrete surfaces where chemical resistance and weather ability are required. A protective and decorative top coat for concrete floors.

BENEFITS
• Attractive - Outstanding gloss and colour retention.
• Versatile - May be applied over most primed substrate. Ultimate  in  protection and decorative.
•  Performance - Unmatched performance by other similar generic type product.
• Compliance  - BS 476 Part 5,6 & 7 for Class '2' fire rating.
• Hard wearing - Recommended for use in vandal/graffiti prone areas.
• Offer slip resistance perfoman.

COLORS
Available in wide range of colors.

FINISH
Gloss, Satin, Matt

SPECIFICATION
DURAPOL 500 Anti Slip (Car Park)  is suitable for use on awide range of substrate with varying service requirements. Specific recommendation, can be obtained upon request.

APPLICATION PRODUCER
SURFACE PREPARATION

DURAPOL 500 Anti Slip (Car Park) shall be applied over clean, dry recommended primer or tie coat.
Mixing Stir each component separately using a high power  (750rpm) electric drill fitted with a paint mixer or a wing type mixing paddle. Then pour the entire content of  Part B into Part A and continue to mix for 2-3 minutes before use. Do not mix more than the required amount within the stipulated pot life.

Thinning
No thinnig required.

Method Of Application
Apply evenly the entire surface using either brush, roller, air less or conventional spray.

Recoating
Touch Dry : 6 hrs. at 25ºC
Maximum Recoating Time : 24hrs. at 25ºC
Minimum Recoating Time : 14hrs. at 25ºC

NOTE :
For best results when spraying, moisture trap should be installed at air inlets to the spray pot to avoid coating contamination. As the Part B is highly sensitive to moisture, it is advis able to use entire content once opened.

HEALTH & SAFETY
This product is highly combustible and contains free isocyanates; use approved respirator during application and provide adequate ventilation. No smoking is allowed. For further information, refer to the product Material Safety Data Sheet, available upon request.

FURTHER INFORMATION
With a wealth of technical and practical experience built up over many years in our pursuit of excellence especially in the protective, flooring and concrete technology, make ETEPOX your patner today!
 

Please leave your enquiry here, we will reply as soon as possible.

Switch To Desktop Version